The BISCO DISPENSER is designed for use with the most current style of mixing cartridges. These cartridges feature an oval shaped base with a "V" cut into one side.

Inserting the cartridge:

1. Release the plunger by pushing up on the release lever located on the rear of the dispenser just below the plunger. While the plunger release is pushed, the plunger is able to slide back and forth freely. Pull it all the way back.

2. Lift the hinged cartridge lock on the top of the dispenser.

3. Place the base of the cartridge into the cartridge receiver that is now exposed. Position the cartridge into the receiver with the "V" cutout facing down.

4. Lock the cartridge into place by returning the cartridge lock to the down position.

Removing the cap and attaching the mixing tip:

1. To remove the cap, turn it 90-degrees counterclockwise and pull it off the cartridge. Retain the cap for reuse. The used mixing tip may also serve as a cap until the next use.

2. Before placing the mixing tip on the cartridge, squeeze the handle of the dispenser until a small amount of material flows from both sides of the cartridge.

3. Select a mixing tip of the same color as the cap (pink, teal, or yellow).

4. Align the small "V"-shaped tab on the base of the barrel of the mixing tip with the "V"-shaped notch on the cartridge. Push the mixing tip onto the cartridge and turn the base of the mixing tip 90-degrees in a clockwise direction.

5. Dispense the desired amount of material by repeatedly squeezing the handle.

NOTE: FOR THOSE WITH SMALLER HANDS, THE ENCLOSED RED INSERT MAY BE PLACED BETWEEN THE TOP OF THE DISPENSER HANDLE AND THE BODY TO REDUCE THE TRAVEL OF THE HANDLE. PICTORIAL INSTRUCTIONS ARE ON THE INSERT CARD.

Removal and Storage:

1. Remove the used mixing tip by turning the base of the mixing tip 90-degrees in a counter-clockwise direction and tilting it down and off the cartridge.

2. Replace the cap by aligning the tab and notch, pushing the cap on and turning clockwise 90-degrees.

3. To remove the cartridge, push the plunger release lever up and fully retract the plunger. Lift the cartridge lock and slide the cartridge up and out of the dispenser.

THE DISPENSER MAY BE CLEANED IN LIQUID DISINFECTANTS OR STERILANTS, OR STERILIZED IN A STEAM AUTOCLAVE. DO NOT STERILIZE IN DRY HEAT OR CHEMICAL VAPOR STERILIZER.

WARRANTY
Bisco, Inc. recognizes its responsibility to replace products if proven to be defective. Bisco, Inc. does not accept liability for any damage or loss, either direct or consequential, stemming from the use of or inability to use the products as described. Before using, it is the responsibility of the user to determine the suitability of the product for its intended use. The user assumes all risk and liability in connection therewith.

CAUTION
U.S. Federal law restricts this device to sale by or on the order of a dental professional.

HOW SUPPLIED:

BISCO DISPENSERxxxxxxxxxxxxxxxx
L-21010P
1 Dispenser, 1 Small Hand Insert, Instructions

Replacement Plunger (1) xxxxxxxxxxxxxxxxx
X-80461D

Bisco, Inc.
1100 W. Irving Park Rd.
Schaumburg, IL 60193
1-(800)-BIS-DENT
847-534-6000

CE ADMINISTRATOR
Bisico France -
Mr. Fred Picavet
L'Opera- BP. 60
13680 Lancon De Provence
France
Phone: 33-490-42-9292
Fax: 33-490-42-9261

IN-070R1
Rev. 2/03