|
Inserting
the cartridge:
1. Release the plunger by pushing up on the
release lever located on the rear of the dispenser just below the
plunger. While the plunger release is pushed, the plunger is able
to slide back and forth freely. Pull it all the way back.
2. Lift
the hinged cartridge lock on the top of the dispenser.
3. Place
the base of the cartridge into the cartridge receiver that is now
exposed. Position the cartridge into the receiver with the "V" cutout
facing down.
4. Lock
the cartridge into place by returning the cartridge lock to the
down position.
Removing the cap and attaching the mixing
tip:
1. To remove the cap, turn it 90-degrees counterclockwise
and pull it off the cartridge. Retain the cap for reuse. The used
mixing tip may also serve as a cap until the next use.
2. Before placing the mixing tip on the cartridge,
squeeze the handle of the dispenser until a small amount of material
flows from both sides of the cartridge.
3. Select a mixing tip of the same color as the
cap (pink, teal, or yellow).
4. Align the small "V"-shaped tab on the base
of the barrel of the mixing tip with the "V"-shaped notch on the
cartridge. Push the mixing tip onto the cartridge and turn the base
of the mixing tip 90-degrees in a clockwise direction.
5. Dispense the desired amount of material by
repeatedly squeezing the handle.
NOTE: FOR THOSE WITH SMALLER HANDS, THE ENCLOSED
RED INSERT MAY BE PLACED BETWEEN THE TOP OF THE DISPENSER HANDLE
AND THE BODY TO REDUCE THE TRAVEL OF THE HANDLE. PICTORIAL INSTRUCTIONS
ARE ON THE INSERT CARD.
Removal and Storage:
1. Remove the used mixing tip by turning the
base of the mixing tip 90-degrees in a counter-clockwise direction
and tilting it down and off the cartridge.
2. Replace
the cap by aligning the tab and notch, pushing the cap on and turning
clockwise 90-degrees.
3. To remove
the cartridge, push the plunger release lever up and fully retract
the plunger. Lift the cartridge lock and slide the cartridge up
and out of the dispenser.
THE DISPENSER MAY BE CLEANED IN LIQUID DISINFECTANTS
OR STERILANTS, OR STERILIZED IN A STEAM AUTOCLAVE. DO NOT STERILIZE
IN DRY HEAT OR CHEMICAL VAPOR STERILIZER.
WARRANTYBisco, Inc.
recognizes its responsibility to replace products if proven to be
defective. Bisco, Inc. does not accept liability for any damage
or loss, either direct or consequential, stemming from the use of
or inability to use the products as described. Before using, it
is the responsibility of the user to determine the suitability of
the product for its intended use. The user assumes all risk and
liability in connection therewith.
CAUTION
U.S. Federal law restricts this device
to sale by or on the order of a dental professional.
HOW SUPPLIED:
BISCO
DISPENSERxxxxxxxxxxxxxxxx
L-21010P
1 Dispenser, 1 Small Hand Insert, Instructions
Replacement Plunger (1) xxxxxxxxxxxxxxxxx
X-80461D
Bisco, Inc.
1100 W. Irving Park Rd.
Schaumburg, IL 60193
1-(800)-BIS-DENT
847-534-6000
CE ADMINISTRATOR
Bisico France -
Mr. Fred Picavet
L'Opera- BP. 60
13680 Lancon De Provence
France
Phone: 33-490-42-9292
Fax: 33-490-42-9261
IN-070R1
Rev. 2/03
|