LIGHT-CORE is a radiopaque, light-cured, fiber-reinforced, core build-up composite. Sculptable and non-slumping, LIGHT-CORE provides a 5mm depth of cure. Optimal handling and excellent viscosity allow for easy contouring. It is available in two shades: TRANSLUCENT and BLUE. LIGHT-CORE is intended for use with universal adhesives, such as the ALL-BOND 2^®*, ONE-STEP^®* or ONE-STEP PLUS. LIGHT-CORE is available in economical syringes and convenient unit-dose tips.

TRANSLUCENT is ideal for use under aesthetic restorations. It achieves a 5mm depth of cure when light-cured for 20 seconds at 500mW/cm².

BLUE is ideal for use in conventional fixed restorations. It facilitates placement when a contrast to tooth structure is required. It achieves a 5mm depth of cure when light-cured for 30 seconds at 500mW/cm².

1. Clean all surfaces that will receive the core material (including the post, if present) with a slurry of pumice and CAVITY CLEANSER™* (disinfectant) or pumice and water. Rinse and dry.

2. Etch the tooth structure using an etchant, such as ETCH-37™* or UNI-ETCH^®*, according to the manufacturer's instructions.

3. Apply an adhesive, such as ALL-BOND 2, ONE-STEP or ONE-STEP PLUS, according to the manufacturer's instructions.

4. If using Unit-Dose Tips, LIGHT-CORE may be injected directly into the preparation, otherwise, dispense desired amount of core material onto a light-protected mixing pad by turning the syringe handle clockwise.

NOTE: To prevent excessive material from extruding from syringe, turn handle counterclockwise immediately after the desired amount is dispensed.

5. Place core material into preparation (and around post, if present) in increments (not to exceed 5mm).

6. Light cure each increment: TRANSLUCENT for a minimum of 20 seconds at 500mW/cm²; BLUE for a minimum of 30 seconds at 500mW/cm².


STORAGE: Store at room temperature (22°C/72°F). Refer to individual component labels for specific expiration dates.

PRECAUTIONS: Unpolymerized resins may cause skin sensitization in susceptible persons. In case of contact with the skin, wash thoroughly with soap and water.

WARRANTY: BISCO, Inc. recognizes its responsibility to replace products if proven to be defective. BISCO, Inc. does not accept liability for any damages or loss, either direct or consequential, stemming from the use of or inability to use the products as described. Before using, it is the responsibility of the user to determine the suitability of the product for its intended use. The user assumes all risk and liability in connection therewith.

CAUTION: U.S. Federal law restricts this device to sale by or on the order of a dental professional.

* LIGHT-CORE, CAVITY CLEANSER and ETCH-37 are trademarks of BISCO, INC.
ALL-BOND 2, ONE-STEP and UNI-ETCH are registered trademarks of BISCO, INC.
Using a halogen curing unit at 0mm from the surface.

BISCO, INC.
1100 W. Irving Park Road
Schaumburg, IL 60193
U.S.A.
847-534-6000
1-800-BIS-DENT
www.bisco.com

CE ADMINISTRATOR
Bisico France -
Mr. Fred Picavet
L'Opera- BP. 60
13680 Lançon De Provence
France
Phone: 33-490-42-9292
Fax: 33-490-42-9261