|
1. Intraoral diagnostic
build-up: without etching or bonding the tooth structure,
build up the tooth/teeth using the Mock-Up Composite.
Light-cure and polish. Check and adjust the occlusion.
2. Fill the impression
tray with the Mock-Up VPS material and make the impression.
Care should be taken to capture the lingual aspect of
the desired teeth.
NOTE: Before use, inspect impression tray to
confirm that it is void of any debris. Trays may be
washed in soap and warm water.
3. Remove the impression
material from the tray. Using a surgical blade, cut
the impression into two halves, length wise, following
the facial-incisal line-angle.
4. Remove the Mock-Up
Composite from the tooth/teeth.
5. Etch the tooth
with phosphoric acid, such as UNI-ETCH®*,
for 15 seconds. Rinse and dry.
6. Apply 2 coats
of adhesive, such as ONE-STEP®* PLUS.
Gently air dry to evaporate solvent. Surface should
be shiny. If not shiny, repeat this step. Light-cure
for 10 seconds per surface.
7. Position the
lingual portion of the impression on the teeth. Using
it as a customized template, place composite, such as
ÆLITE™*, to restore the lingual
aspects of the tooth.
8. Once the lingual
aspect of the restoration has been built up, the customized
template can be removed.
9. Continue restoration
of the tooth/teeth with composites, such as ÆLITE.
STORAGE: Store at room temperature (22°C/72°F).
See individual component labels for specific expiration
dates.
PRECAUTIONS: Unpolymerized resins may cause skin
sensitization in susceptible persons. In case of contact
with the skin, wash thoroughly with soap and water.
WARRANTY: Bisco, Inc. recognizes its responsibility
to replace products if proven to be defective. Bisco,
Inc. does not accept liability for any damage or loss,
either direct or consequential, stemming from the use
of or inability to use the products as described. Before
using, it is the responsibility of the user to determine
the suitability of the product for its intended use.
The user assumes all risk and liability in connection
therewith.
CAUTION: U.S. Federal law restricts this device
to sale by or on the order of a dental professional.
* UNI-ETCH and ONE-STEP are registered trademarks of
BISCO, INC.
* ÆLITE is a trademark of BISCO, INC.
Bisco, Inc.
1100 W. Irving Park Road
Schaumburg, IL 60193
U.S.A.
847-534-6000
1-800-BIS-DENT
www.bisco.com
IN-156
Rev. 6/06
|
