The Mock-Up Kit offers a convenient way to create a template of the anterior teeth and consists of composite, an impression tray, impression material and mixing tips. The Mock-Up composite in this kit may be used to quickly build up the desired shape of the final restoration. Think of it as a diagnostic build-up performed intraorally. The impression tray, impression material and mixing tips are used to capture the contours created with the composite. The impression material also doubles as a matrix, allowing you to build-up the lingual surfaces and incisal edges of the anterior teeth effortlessly.

1. Intraoral diagnostic build-up: without etching or bonding the tooth structure, build up the tooth/teeth using the Mock-Up Composite. Light-cure and polish. Check and adjust the occlusion.

2. Fill the impression tray with the Mock-Up VPS material and make the impression. Care should be taken to capture the lingual aspect of the desired teeth.

NOTE: Before use, inspect impression tray to confirm that it is void of any debris. Trays may be washed in soap and warm water.

3. Remove the impression material from the tray. Using a surgical blade, cut the impression into two halves, length wise, following the facial-incisal line-angle.

4. Remove the Mock-Up Composite from the tooth/teeth.

5. Etch the tooth with phosphoric acid, such as UNI-ETCH^®*, for 15 seconds. Rinse and dry.

6. Apply 2 coats of adhesive, such as ONE-STEP^®* PLUS. Gently air dry to evaporate solvent. Surface should be shiny. If not shiny, repeat this step. Light-cure for 10 seconds per surface.

7. Position the lingual portion of the impression on the teeth. Using it as a customized template, place composite, such as ÆLITE^™*, to restore the lingual aspects of the tooth.

8. Once the lingual aspect of the restoration has been built up, the customized template can be removed.

9. Continue restoration of the tooth/teeth with composites, such as ÆLITE.


STORAGE: Store at room temperature (20°C/68°F - 25°C/77°F). See individual component labels for specific expiration dates.

PRECAUTIONS: Unpolymerized resins may cause skin sensitization in susceptible persons. Avoid contact with skin. In case of contact with the skin, wash thoroughly with soap and water.

WARRANTY: BISCO, Inc. recognizes its responsibility to replace products if proven to be defective. BISCO, Inc. does not accept liability for any damage or loss, either direct or consequential, stemming from the use of or inability to use the products as described. Before using, it is the responsibility of the user to determine the suitability of the product for its intended use. The user assumes all risk and liability in connection therewith.

CAUTION: U.S. Federal law restricts this device to sale by or on the order of a dental professional.

* UNI-ETCH and ONE-STEP are registered trademarks of BISCO, INC.
* ÆLITE is a trademark of BISCO, INC.


Bisco, Inc.
1100 W. Irving Park Road
Schaumburg, IL 60193
U.S.A.
847-534-6000
1-800-BIS-DENT
www.bisco.com

IN-156R1
Rev. 10/08