MODELING RESIN is a light-cured, low viscosity microfilled (30% by weight) resin formulation for use as a composite sculpting resin. The properties of composite naturally lend itself to adhere (stick) to your instrument. To overcome this aggravating tackiness, MODELING RESIN was developed to aid in the placement and shaping of your composites. By wetting your instrument, MODELING RESIN can be used to place and manipulate (sculpt) all of your direct composite restorations.

1. Remove cap and place tip on syringe. Dispense one or two drops of MODELING RESIN into a clean mixing well or onto a mixing pad.

2. Following placement of initial increment of composite to prepared site, dip composite instrument into MODELING RESIN. With MODELING RESIN on the instrument, sculpt your restoration and manipulate the composite to desired shape.

3. Light-cure. Although MODELING RESIN requires light-curing for ten (10) seconds, follow the curing time recommendations from your composite manufacturer to ensure thorough curing of composite increment. Additional composite increments will adhere to cured MODELING RESIN.

STORAGE: Store at room temperature (22°C/72°F). Refer to individual component labels for specific expiration dates.

PRECAUTIONS: Uncured resins may cause skin sensitization in susceptible persons. In case of contact with the skin, wash thoroughly with soap and water.

WARRANTY: Bisco, Inc. recognizes its responsibility to replace products if proven to be defective. Bisco, Inc. does not accept liability for any damage or loss, either direct or consequential, stemming from the use of or inability to use the products as described. Before using, it is the responsibility of the user to determine the suitability of the product for its intended use. The user assumes all risk and liability in connection therewith.

CAUTION: U.S. Federal law restricts this device to sale by or on the order of a dental professional.

HOW SUPPLIED:

REF G-9316P
2 Syringes MODELING RESIN (1.5g ea.), 20 Black Disposable Syringe Tips, Instructions/MSDS

Bisco, Inc.
1100 W. Irving Park Rd.
Schaumburg, IL 60193
1-(800)-BIS-DENT
847-534-6000

CE ADMINISTRATOR
Bisico France -
Mr. Fred Picavet
L'Opera- BP. 60
13680 Lancon De Provence
France
Phone: 33-490-42-9292
Fax: 33-490-42-9261

IN-129
Rev. 3/03