NOTE: Allow material to reach room temperature prior to use.
1. Prophylaxis - thoroughly clean the teeth to
be bonded with pumice in a rubber cup or bristle
brush. Carefully avoid irritating the gingival
tissue since slight bleeding may cause contamination
and could affect bonding quality.
2. Rinse thoroughly with plenty of water. Isolate
the teeth and dry with an air syringe.
3. Apply ORTHO BAND PASTE LC on the internal
side of the band.
4. Seat the band on the tooth to the desired position.
5. Light cure the paste from the occlusal surface for 10 seconds @ 500mW/cm2. Remove the excess material (it should come off easily).
6. Light cure from the occlusal surface for an additional 20 seconds @ 500mW/cm2 or until completely cured.
STORAGE: Refrigerate when not in use (overnight) (2°C/36°F - 8°C/46°F). Refer to individual component labels for specific expiration dates.
PRECAUTIONS: Unpolymerized resins may cause skin sensitization in susceptible persons. In case of contact with the skin, wash thoroughly with soap and water.
WARRANTY: BISCO, Inc. recognizes its responsibility to replace products if proven to be defective. BISCO, Inc. does not accept liability for any damages or loss, direct or consequential, stemming from the use of or inability to use the products as described. Before using, it is the responsibility of the user to determine the suitability of the product for its intended use. The user assumes all risk and liability in connection therewith.
CAUTION: U.S. Federal law restricts this device to sale by or on the order of a dental professional.
BISCO, INC.
1100 W. Irving Park Rd.
Schaumburg, IL 60193
U.S.A.
847-534-6000
1-800 BIS-DENT
www.bisco.com
CE ADMINISTRATOR
Bisico France
Mr. Fred Picavet
L'Opera- BP. 60
13680 Lançon De Provence
France
Phone: 33-490-42-9292
Fax: 33-490-42-9261
IN-133R2
Rev. 4/08
|