|
|
| |
 |
FIBER
POST REMOVAL KIT
Instructions |
 |
|
|
|
.U.S.
Patent #'s 5,328,372 & 4,738,616
The FIBER POST REMOVAL KIT was designed for removal of
BISCO'S FIBER POSTS (LIGHT-POST™, AESTHETI-PLUS™, AESTHETI-POST™,
C-POST™) and U.M. FIBER POSTS (U.M. AESTHETI-PLUS™ and
U.M. C-POST™).
HOW SUPPLIED:
REF X-80681P
One Pin-Pilot Drill, One Nickel-Titanium Drill, One #2
Peeso Reamer, Instructions.
Export Only
REF X-80681PX
One Pin-Pilot Drill, One Nickel-Titanium Drill, One #2
Peeso Reamer, Instructions.
PRECAUTIONS: It is recommended to use a new kit
for each removal procedure for optimal results and to
prevent drill breakage in the canal. To reduce heat, copious
water irrigation must be used during post removal.
C-POST is marketed outside of the U.S. under the trade
name COMPOSIPOST.
U.M. Aestheti-Plus is marketed outside of the U.S. under
the trade name Endo Plus
| FIBER
POST REMOVAL TECHNIQUE |
 |
1)
Drill an orientation hole with the pin-pilot drill
through the center of the post. |
 |
2)
Using the Nickel-Titanium drill (safe tip) at 15000
RPM, gently begin drilling a hole through the center
of the post. This will begin to hollow out the post.
NOTE: A gentle water spray is recommended during
removal to reduce heat. |
 |
3)
Using the #2 Peeso Reamer (safe tip) gently drill
through the hollow post again, with pressure applied
peripherally. The hollowed post will get slightly
larger but still be intact. |
 |
4)
FIBER POST: Use the Pre-Shaping drill (one
stripe) corresponding to the post size to remove
most of what is left of the post.
U.M. FIBER POST: Use an ISO #70 drill to
remove most of what is left of the post
|
 |
5)
FIBER POST: Use the Finishing Drill (two
stripes) corresponding to the post size to remove
any of the remaining post.
U.M. FIBER POST: Use drills corresponding
to the post size to remove any of the remaining
post. (e.g. to remove a ISO #120 post, use drill
ISO #70 followed by ISO #100 and then ISO #120).
|
|
CAUTION:
U.S. Federal law restricts this device to sale by or on
the order of a dental professional.
Bisco, Inc.
1100 W. Irving Park Rd.
Schaumburg, IL 60193
1-(800)-BIS-DENT
847-534-6000
CE ADMINISTRATOR
Bisico France -
Mr. Fred Picavet
L'Opera- BP. 60
13680 Lancon De Provence
France
Phone: 33-490-42-9292
Fax: 33-490-42-9261
IN-069
Rev. 12/99 |
|
|
