|
|
| |
 |
ALL-BOND®
2 TECHNIQUE GUIDE |
 |
|
|
ALL-BOND 2 Technique Cards are provided
as a concise chairside guide to various clinical procedures.
Flip through the cards until you find the procedure you
are about to perform. Should you need materials other
than those supplied in the ALL-BOND 2 kits, they will
be listed under "Also Needed".
ALL-BOND 2 Adhesive Kits contain one of two different
semi-gel etchants. UNI-ETCH® is 32% H3PO4
used primarily for etching enamel and dentin and ALL-ETCH®
is 10% H3PO4 for etching enamel
and dentin with agitation on enamel. Both etchants contain
benzalkonium chloride as an effective microbial disinfectant.
Special attention should be paid to the tooth before applying
Etch. After etching and rinsing, remove pooled water from
the preparation without drying out the dentin surface.
Desiccating dentin and enamel may result in reduced bond
strength. However, moisture resulting from saliva contamination
is to be avoided. On the other hand, incomplete drying
or evaporation of solvents from the applied primers may
lead to reduced bond strength and post-operative sensitivity.
Refer to the enclosed instructions for more detailed explanations.
RESINOMER™ (available separately) is a dual cure fluoride
releasing, adhesive, composite liner. RESINOMER bonds
tenaciously to ALL-BOND 2 as well as amalgam resulting
in an effective adhesive restorative system. RESINOMER
is a low viscosity resin composite containing DSDM. This
Bisco developed monomer forms strong micromechanical as
well as chemical bonds to all dental metals.
The following table is provided to assist you in selecting
OPAQUER shades to match the Vita Shade guide. Consult
this table when opaquing a metal surface before restoring
with composite or porcelain.
|
Shade
Of Opaquer Base
L
U
G
Y
DY |
VITA®
Shade Coverage
A1,B1,C1
A2,B2,D2
C2,C3,C4,D3,D4
A3,B3,D4
A3.5,A4 (A5)* |
* Additional shade developed by Bisco that is much darker
than A4.
|
| |
|
|
