null
Skip to main content
Buy 1 All-Bond Universal, get a 4-5g pack of Select HV Etch w/BAC FREE

Valid on the 6ml bottle only. Use Promo code 26BOND4. U.S. Customers only. Discount cannot be combined with any other offer. Unlimited quantities. Expires 12/31/26.

Shop All-Bond Universal
All-Bond Universal Bottle by BISCO
All-Bond Universal

BISCO’s All-Bond Universal is a light-cured, universal adhesive.

TheraCal LC by BISCO
TheraCal LC

BISCO’s TheraCal LC is a light-cured, resin-modified calcium silicate material.

TheraCem by BISCO
TheraCem Dual-Syringe

TheraCem is a self-adhesive, calcium and fluoride releasing, dual-cured resin cement.

Z-Prime by BISCO
Z-Prime Plus

Z-Prime Plus is a single component priming agent for Zirconia, Metal, and Alumina substrates.

TheraCem is selected as a dual-cure resin cement that supports simplified cementation workflows by reducing the need for separate bonding agents while maintaining compatibility with zirconia and metal substrates.

See below for the Step-by-Step technique.

Self-Adhesive Cementation of Zirconia or Metal step 1
STEP 1

Sandblast

Sandblast internal surface of restoration (unless restoration has been previously sandblasted).
Self-Adhesive Cementation of Zirconia or Metal step 2
STEP 2

Temporary Restoration

Remove temporary restoration and clean prep with pumice and water slurry. Rinse thoroughly and dry.
Self-Adhesive Cementation of Zirconia or Metal step 3
STEP 3

Occlusion

Try-in to check occlusion and fit. After try-in, thoroughly rinse the restoration with water spray and dry.
Self-Adhesive Cementation of Zirconia or Metal step 4
STEP 4

Clean

Metal/Zirconia/Indirect Composite: Outside of the mouth, cover all bonded surfaces of the restoration with a layer of ZirClean®. Allow 20 seconds for the cleaning action of ZirClean to take affect, then thoroughly rinse with water spray and dry.
Self-Adhesive Cementation of Zirconia or Metal step 5
STEP 5

Cementation

Dispense TheraCem into the restoration. Seat the restoration with gentle passive pressure and remove any excess cement.
PRO TIP: To aid in the removal of excess cement, initially light cure the margins for 2-3 seconds.
Self-Adhesive Cementation of Zirconia or Metal step 5
STEP 6

Light Cure

Light cure for 20-30 seconds or allow to self cure.

Not this case? Explore other procedures.

Quickly find the right materials for your next procedure.