Self Etch - All-Bond Universal
The self etch procedure uses no application of phosphoric acid to tooth structure.
BISCO Recommends
All-Bond Universal® simplifies self-etch procedures by combining adhesion with a streamlined application protocol. This universal adhesive helps reduce sensitivity while delivering reliable bond strength to both enamel and dentin. Keep scrolling for BISCO's recommended Step-by-Step technique.
STEP 1
No phosphoric acid
No phosphoric acid applied to the tooth structure.
STEP 2
Apply
Apply two separate coats of All-Bond Universal, scubbing the preparation with a microbrush for 10-15 seconds per coat. Do not light cure between coats.
STEP 3
Evaporate solvent
Evaporate solvent by thoroughly air-drying with an air syringe for at least 10 seconds; there should be no visible movement of the material. The surface should have a uniform glossy appearance; otherwise, repeat Step 1-2. Light cure for 10 seconds.
STEP 4
Placement
Continue with placement of the restorative material according to the manufacturer's instructions.
